Quick answer
Assemble the ten Breachers in two stages: build the five specialists first, then the close-combat rank and file, and dry-fit every arm before gluing. For play, keep the squad tight around cover and push through the narrowest lane your opponent has to contest.
Why the build order matters more than the paint scheme
Breachers are a close-confines unit, so their value on the table comes from arriving intact and getting into tight terrain. That makes the assembly stage the one place where a small mistake costs you games: a specialist glued in the wrong pose can block line of sight for the models behind it, and arms fitted after the torso is closed are harder to align cleanly.
Painting follows the same logic. Void armour is mostly enclosed, so the visible detail is concentrated at the helmet, chest seal and weapon. Paint those areas before final assembly where you can, and accept that some interior surfaces will never be seen.
Where the Breachers fit and where they do not
This is a boarding and close-quarters squad, not a gunline. It rewards players who plan a route through dense terrain and punish anyone who leaves it standing in the open trading shots at range.
If your collection is built around long-range firepower, Breachers will feel like an awkward addition unless you also plan a delivery route. If you already play aggressive infantry that wants to reach the middle of the board, they slot in naturally.
Step-by-step: assemble, paint and field the squad
- 1. Sort the sprue by role before clipping: Lay out the components and separate the specialist parts from the standard close-combat bodies. Decide which five models will carry the specialised gear and which five will form the rank and file. Photograph your sorted layout so you can match parts after cleanup.
- 2. Clean and dry-fit every join: Remove mould lines from armour edges and test-fit each arm and weapon against the torso before glue. Enclosed void armour leaves little room for adjustment once the torso halves are closed. If a shoulder join will not sit flush, trim the contact point rather than forcing it.
- 3. Build the five specialists first: Assemble the models carrying the more specialised gear ahead of the rank and file. Their poses are the least flexible, so they set the spacing for the rest of the squad. Keep specialist weapons angled outward so they do not overlap a neighbour's base.
- 4. Build the rank and file around them: Add the standard close-combat models, varying leg and torso angles so the squad does not look like a repeated pose. Check that no weapon crosses into another model's silhouette. Stagger the front rank slightly so every helmet is visible from the table edge.
- 5. Base before you prime: Fix each model to its base and check the squad ranks up without overlap. Textured bases are easier to add now than after the armour is painted. Leave the underside of each base clean for your holder or handle.
- 6. Prime and block in the armour: Prime in a light tone, then block in the main void-armour colour across the enclosed plates. Keep the coverage thin and work in batches of five so the squad stays consistent. Record the exact colours used so later additions match.
- 7. Paint the focal details: Concentrate effort on the helmet lenses, chest seal, weapon casings and any specialist gear. These are the areas opponents actually see at arm's length on the table. Pick one accent colour and repeat it on every model to tie the squad together.
The kit at a glance
- Warhammer 40000: Armies of the Imperium: Imperial Agents: Imperial Navy Breachers: Multipart plastic kit that builds a squad of 10 Imperial Navy Breachers in enclosed void armour. Ten models is enough for one full squad, so plan your specialist and rank-and-file split before you start clipping.

Warhammer 40000: Armies of the Imperium: Imperial Agents: Imperial Navy Breachers


