Ultraman Rising Entry Grade: Build and Display Tips

Quick answer

Build the Ultraman Rising Entry Grade kit by following the touch-gate system, then display it in a fixed pose with minimal cleanup. It's designed for first-time builders, so you can finish it in about 30 minutes.

Step-by-step build and display guide

1. Prepare your workspace: Clear a flat surface with good lighting. Have a pair of hobby nippers or just your hands, since the touch-gate system allows clean removal without tools. Check that you have enough space to lay out all runners without mixing up parts.
2. Snap parts using touch gates: Twist or cut each part from the runner at the touch gate. Avoid pulling too hard, as this can stress the plastic and leave marks. If a part feels tight, use a hobby knife to trim the gate slightly before forcing it.
3. Assemble in order: Follow the instruction manual, starting with the torso and head, then arms and legs. The kit is designed for a fixed pose, so alignment is straightforward. Double-check that each joint clicks fully into place before moving to the next section.
4. Clean up nubs and seams: Use a hobby file or fine sandpaper to smooth any remaining nubs. Since the kit uses touch gates, cleanup is minimal, but a quick pass improves the finish. Be gentle to avoid scratching the plastic; a light touch is enough.
5. Display with a simple stand or shelf: Place the finished Ultraman on a shelf or in a display case. Because the pose is fixed, it stands securely without a base, but a clear stand adds stability if needed. Consider adding a small LED light to highlight the silver and red details.

Product spotlight

• Ultraman Entry Grade #00 Ultraman Rising: The Ultraman Entry Grade #00 Ultraman Rising kit stands approximately 5.9 inches tall and features a fixed pose, with parts that reproduce the film's design. This means you get a screen-accurate display piece without needing advanced building skills, perfect for a quick weekend project.