How to Apply QLIA Glow in the Dark Stickers on Gunpla

By GUNNZO | Published: 2026-10-28

Category: How-to Guides

Learn how to apply QLIA Glow in the Dark Stickers to your Gunpla or model kits for a fun, low-light effect. Step-by-step guide with tips for best adhesion and glow.

Quick Answer

Clean the surface, peel the QLIA Glow in the Dark Sticker from the backing, press it firmly onto your model kit, and then charge the glow effect with a bright light source.

Why Use QLIA Glow Stickers on Model Kits?

QLIA Glow in the Dark Stickers add a playful, kawaii touch to your Gunpla or other model kits. Their 3D epoxy resin design gives a tactile, raised look that stands out even in normal light. The real magic happens in low-light settings, where the glow effect makes your build pop during evening displays or photos.

These stickers work well on smooth, flat surfaces like shoulder armor, chest plates, or shield faces. Avoid highly curved or textured areas, as the 3D epoxy may not adhere fully.

Limitations to Know Before You Start

The glow duration depends on how long you charge the stickers under a bright light. For best results, use a UV flashlight or direct sunlight for 1-2 minutes. The effect is noticeable but not as intense as phosphorescent paints.

Because of the 3D epoxy resin, these stickers add slight thickness. They may not sit flush on joints or moving parts, so test placement before committing.

Step-by-Step Application Process

1. Clean the Surface: Wipe the area where you’ll place the sticker with a lint-free cloth and isopropyl alcohol. This removes oils and dust that can weaken adhesion. Skipping this step may cause the sticker to peel off after a few days.
2. Test the Placement: Hold the sticker against the model kit without removing the backing. Check that the surface is flat enough for the 3D epoxy to sit evenly. Mark the spot lightly with a pencil if needed. Avoid curved or textured surfaces—the sticker won’t adhere fully and may lift at the edges.
3. Peel and Apply: Carefully peel the sticker from its backing using tweezers for precision. Position it over your marked spot and press from the center outward with your fingertip or a soft cloth. If the sticker bends or folds during application, it may not lie flat. Use fresh tweezers with a fine tip.
4. Press Firmly and Evenly: Apply steady pressure for 10-15 seconds, especially around the edges. Use a blunt tool like a model kit spatula to smooth out any air bubbles. Air bubbles trapped under the 3D epoxy are hard to remove later, so take your time.
5. Charge the Glow: Expose the sticker to a bright light source—UV flashlight, LED desk lamp, or direct sunlight—for 1-2 minutes. The longer you charge, the brighter and longer the glow lasts. A quick 10-second flash won’t produce a visible glow. Charge fully before a dark-room display.

Product Used in This Guide

QLIA Stickers:91153 Glow in the Dark Stickers: QLIA Glow in the Dark Stickers feature a 3D epoxy resin design and a glow-in-the-dark effect for low-light visibility. The raised 3D texture adds visual depth to your model kit, while the glow effect creates a unique display feature in dark environments.
QLIA Stickers:91153 Glow in the Dark Stickers